BETAThis is a new independent transparency project, not an official government website. The data is sourced from public registers and may contain errors, so always verify against the official source. If you find a problem, please report it here.
AMIC wishes to procure a Tool Pre-Setting Area for CNC machining. AMIC will use the software and equipment to set, balance, heat shrink, and monitor cutting tools offline, improving setup efficiency and machining performance. It will support training in state-of-the-art presetting and tool management practices, while enabling digital integration and data-driven workflows to enhance control, consistency, and advanced manufacturing capability.
The equipment will be located at the AMIC Factory of the Future, Global Point Newtownabbey, a facility for collaborative research projects with industry partners, therefore the Tool Pre-Setting Area will have lower usage rates than it would in a manufacturing environment. For a comprehensive description of the requirements please refer to document 260026 Contract Specification.
| Supplier | Identifier | Award Value | Lots Won | Cross-References |
|---|---|---|---|---|
| Zoller UK Ltd | 08335264 | £470,796 | 1 lot Lot 1 | - |
Taken from this notice, not from Companies House. Check the original notice — details change and are not updated here.
This procurement was divided into 1 lots, each awarded separately. 3 bids were received in total.
| Lot | Value | Bids Received | Awarded To | Status |
|---|---|---|---|---|
| Lot 1 Sept 2026 – Sept 2029 | £341,585 | 3 | pending |
Weightings from the notice.
Changes the buyer published to this notice after it first appeared.
The end date of the contract was updated to read 14 September 2029 instead of 17 September 2029
The closing date of this tender has been extended to 3 August 2026. The estimated award decision date was extended to 7 September 2026