Loading contract…
BETAThis is a new independent transparency project, not an official government website. The data is sourced from public registers and may contain errors, so always verify against the official source. If you find a problem, please report it here.
De Montfort University (DMU) seeks to engage a suitably qualified and experienced Contractor to carry out the following works:
o The works comprise of the swapping over of areas between 3D Printing and the Metalwork shop on the ground floor of the Vijay Patel building.
o This is to be carried out in two phases with Phase 1 the alteration of the existing 3D Printing area into a metalwork shop.
o On completion of this phase, Phase 2 will be the conversion of the metalwork shop into the new 3D Printing area.
o A suggested programme has been included within the tender
The intended key project dates are as follows:-
Start on Site - 04/09/2023
Practical Completion - 01/12/2023
Duration - 12 Weeks
Full details of the University's requirements can be found in the attached tender pack.
Additional information:
Is a Recurrent Procurement Type? : No
No supplier information available.