Loading contract…
BETAThis is a new independent transparency project, not an official government website. The data is sourced from public registers and may contain errors, so always verify against the official source. If you find a problem, please report it here.
The Science Division (SD) of the Health and Safety Executive invites bids for the Supply, Build and Installation of a Low humidity/Oxygen Glove box for battery cell analysis post-destruction, and for cell disassembly, Buxton SK17 9JN.
Basic information:
⢠A two glove design chamber, with low moisture (<1ppm) and low humidity (<1ppm) gas purification system.
⢠Should have both a large antechamber, and a smaller one for pass through of tools/small objects.
⢠Should come with stand, and illumination for interior.
⢠Gas purification system should be capable of regeneration. Should give real-time indication of current oxygen/humidity levels.
⢠Should be capable of working under slight positive or negative pressures (as set).
⢠Ideally would also contain a purification system for removal of solvent vapours. Most ideally, this should be regenerable.
⢠Ideally would be of design concept would be modular to allow future expansion.
A full, detailed specification can be found in the ITT document pack and can be downloaded from the In-Tend portal.
Additional information: All tender documents are available via the HSE In-Tend supplier e-procurement portal. All responses and requests for clarification must be submitted via the portal. Registration is free of charge and can be completed via the following link:
No supplier information available.